Stainless Steel Pipe Fittings

Selection of stainless steel for handling acetic acid CH3COOH By yaang.com

Written by
Selection of stainless steel for handling acetic acid CH3COOH By yaang.com

Acetic acid is a weak reducing acid. It is used in plastics manufacture and is a constituent of foods as vinegar. Ferritic stainless steels such as 430 type can be considered but normally the 304 types are used for most applications, including handling and storage. 
Acetic anhydride (CH3CO)2O can be aggressive to either 304 or 316 types in the absence of any water and in the presence of chlorides. Peracetic acid CH3C(O)OOH (peroxyacetic acid) should be safe with stainless steel.Vinyl acetate C4H6O2 may be considered with the 316 grades for ambient temperature storage applications.

Commercially concentrated acid is around 99wt. % (glacial acetic acid).

Corrosion resistance of stainless steel

Ferritic stainless steel such as the 430 / 1.4016 type can be considered for most acid concentrations at ambient temperatures, but normally austenitic are preferred as pitting corrosion has been reported in industrial plant and equipment.

The 304 types are normally considered as suitable grades for most applications, including handling and storage.

The iso-corrosion diagram 0.1mm/year lines for the 316 / 1.4401 (red) types show that they can be expected to provide better resistance over about 5% concentrations, at temperature over 90 degC, than the 304 (blue) types.

(The boiling point corresponds to the red line for 316 types)

Selection-of-stainless-steel-for-handling-acetic-acid-CH3COOH

At concentrations above about 80%, the 316 types are usually considered a better choice than the 304 types, especially where temperatures exceed 70 degC, where there is a risk of localised attack to the 304 types.

For processing equipment, 316L is considered a better choice than the 30

4/304L or 316 types.

Intergranular attack can be an issue in weld heat affected zones, if acid contact temperatures exceed around 60 degC. As with other similar acid contact applications, the low carbon, 304L should be considered rather than the standard 304 types.

In common with most acid handling applications, chloride contamination can cause pitting corrosion and so in these cases more pitting resistant grades may need to be considered. Contamination of acetic acid with the more aggressive formic acid (HCOOH) can result in an unexpected reduction in corrosion resista

nce of the 316 types. The 304 types may be particularly vulnerable under these conditions.

Acetic anhydride (CH3CO)2O

Acetic anhydride (CH3CO)2O can be aggressive to either 304 or 316 types in the absence of any water and in the presence of chlorides.
The risk of pitting corrosion can be reduced if grades such as the austenitic 1.4539 or the 6% molybdenum grades are considered in these extreme conditions.

Peracetic acid CH3C(O)OOH

Peracetic acid CH3C(O)OOH which is also known as peroxyacetic acid, is used as a disinfectant (sanitiser) in food, medical and water treatment related industries.
It should be safe for uses that involve contact with stainless steel items.

Vinyl acetate C4H6O2

Vinyl acetate C4H6O2 is an intermediate product used in the manufacture of chemicals such as adhesives and paints.
The only information available suggests that the 316 types should be suitable for ambient temperature storage applications.

Source: Zhejiang Yaang Pipe Industry Co., Limited (www.yaang.com)

Article Categories:
Stainless Steel

Leave a Comment

Your email address will not be published. Required fields are marked *